Chapin 22149XP Bedienungsanleitung PDF herunterladen

6-4607

Pressure Relief Valve

Válvula de descarga de presión

Soupape de décompression

WARNING!

1) Do: Check tightness of hose nut to be sure hose is securely attached to the tank outlet.

2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of these conditions are found,

replace hose before using. Replace with original manufacturer’s parts only.

3) Do: Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and exterior of tank

for signs of deterioration of body and bottom. Any sign of deterioration indicates possible tank weakening and

could result in explosive bursting under pressure. If any of these signs are found, discard tank immediately and

replace. Do not attempt to patch leaks, etc., as this could result in serious injury.

4) Do: Follow Filling, Pressurizing and Spraying Instructions, except use water only.

5) Do: Pump plunger 8-10 strokes and inspect for leaks.

6) Do: Direct shut-o away from you and open to make sure discharge is not clogged.

7) Do: If unit passes this test, release pressure (see Pressure Releasing Instructions), empty tank, and proceed with

Filling, Pressurizing and Spraying Instructions.

3. Pre-Use Check

4. Filling

1) Do: Turn pump handle counterclockwise and remove pump

2) Do: Prepare spray solution following all directions and safety warnings on chemical label.

3) Do: Fill tank to no more than the proper gallon marker. Do NOT: over ll to accommodate pump.

4) Do: Check pump to make sure that no grass or dirt is stuck to barrel. Replace pump in tank and tighten

securely.

9. Care, Storage and Maintenance

1) Do: Rinse tank thoroughly with water only, empty, rell with water. Follow Filling, Pressurizing

and Spraying Instructions, except pump unit only 8-10 strokes.

2) Do: Open shut-o and allow water to run through discharge assembly.

3) Do: Release pressure (Follow Pressure Release Instructions), remove pump and empty sprayer.

4) Do: Store sprayer tank upside down, with pump removed, in a warm dry location.

5) Do: Periodically oil pump by dropping 10-12 drops of light oil down pump rod through

opening in cover.

011534-4 (A) R0412

P.O. Box 549 700 Ellicott St.

Batavia, NY 14021-0549 U.S.A.

1-800-950-4458 www.chapinmfg.com

WARNING: Handling the brass parts of this product will expose you to lead, a chemical known

to the State of California to cause birth defects and other reproductive harm. Wash hands after

handling.

Hazard: Improper use or failure to follow instructions can result in explosive failure causing

serious eye or other injury. For safe use of this product you must read and follow all instructions.

Do not leave a pressurized sprayer in the hot sun. Heat can cause pressure build-up. Do not store

or leave solution in tank after use. Always wear goggles, gloves, long sleeve shirt, long pants and full

foot protection when spraying. Never use any tool to remove pump if there is pressure in sprayer.

Never stand with face or body over top of tank when pumping or loosening pump to prevent eject-

ing pump assembly and/or solution from striking and injuring you. Never pressurize sprayer by any

means other than the original pump. Do not attempt to modify or repair this product except with

original manufacturer’s parts. Never spray ammable materials or heat, pressure, or gas produc-

ing chemicals. Always read and follow manufacturer’s instructions before use with this sprayer

as some chemicals may be hazardous when used with this sprayer.

Sk-1113-1

1. Hose to Tank

Discharge/ Assembly

• Make sure white outlet tube is attached to outlet tube adapter (Fig. 1A).

• Insert the outlet tube portion of the discharge assembly into the tank adapter (Fig. 1B).

• Proper placement of white outlet tube (Fig. 1C).

• Firmly insert the outlet tube adapter into the tank adapter (Fig. 1D) Lining up tab

with notches on the tank adapter.

• Firmly tighten the retaining nut to the tank adapter (Fig. 1E).

Discharge

Assembly

Outlet

Tube

Retaining Nut -

Securely tightened.

1C 1D

Gap

Tank

Adapter

Outlet Tube

Adapter

Tab/

Notch

Outlet Tube

Adapter

Outlet

Tube

Parts, Piezas, Pièces

Repair Parts Kit Gaskets and Seals (not included),

Juego de piezas de reparación, empaquetaduras y juntas (no incluido)

Kit de pièces de réparation, joints et garniture d’étanchéité (non inclus) 6-5387

Note: Your particular sprayer may not include all parts pictured above.

Nota: Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.

Remarque : Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.

6-5943

Nozzle 1.0 GPM

Tobera

Buse

6-5797

Nozzle .5GPM

Tobera

Buse

Congratulations!

You have just purchased a quality Chapin product.

Questions?

Do Not Return To Store.

Call us @ 1-800-950-4458 or www.chapinmfg.com

¡Felicitaciones!

Usted acaba de adquirir un producto de calidad Chapin.

Registre su pulverizador en línea en www.chapinmfg.com

¿Preguntas?

No regrese a la tienda;

llámenos al 1-800-950-4458 o visite www.chapinmfg.com

Félicitations!

Vous avez acheté un produit de qualité Chapin.

Enregistrez dès que possible votre pulvérisateur en ligne à l'adresse suivante:

www.chapinmfg.com

Questions ?

Ne retournez pas au magasin.

Appelez-nous 1-800-950-4458 ou visitez le www.chapinmfg.com

6-6090

Hose Black

Manguera para trabajos pesados Negro

Tuyau pour service intense Noir

6-8136

Valve Kit

Kit de la válvula

Ensemble de soupape

6-8135

Dripless Shut-o

Cierre antigoteo

Arrêt anti-goutte

2. Nozzle

Attach nozzle to shut-o handle or extension wand.

2A 2B

Valve Seat

Nozzle Adapter

Nozzle

To attach nozzle to shut-o, unthread nozzle adapter and re-

move valve seat from extension (2B). Unthread brass extension

nut and metal rod (2D). Assemble valve seat to shut-o then

assemble nozzle adapter as shown in gure (2A).

Note orientation of valve seat. It will leak if assembled wrong .

Metal Rod Brass Extension

Brass Extension Nut

Metal Rod

301630-3

Pump Assembly

Asamblea de la bomba

Assemblée de pompe

For safety lock-o feature (no-spraying), push trigger forward

and rotate locking mechanism into lock-o position as shown

in g. 6A.

6. Lock Off

Lock

Trigger

5. Pressurizing and Spraying

Do: Turn handle clockwise to

tighten. Push handle down,

turn 1/4 turn counterclock-

wise to release.

Do: Pump until you

feel resistance.

Do: Push handle, down, turn

1/4 turn clockwise to lock. Begin

spraying. Re-pump sprayer as

required to maintain spray force.

7. To Release Pressure

1) Your sprayer is equipped with a pressure relief/release valve

(Fig. 7A). To release pressure lift and hold the cap until air

is completely exhausted, OR, turn the valve slowly counter

clockwise until you hear air escaping and wait air is completely

exhausted (Fig. 7B).

2) Do: Stay away from the sprayer until all air has escaped.

8. Wand Dock Clip

Choose the holder that ts your wand.

1 2

Inhaltsverzeichnis

Seite 1 - WARNING!

6-4607Pressure Relief ValveVálvula de descarga de presiónSoupape de décompressionWARNING!1) Do: Check tightness of hose nut to be sure hose is secure

Seite 2 - ADAVERTISSEMENT

011534-4 (B) R0412P.O. Box 549 700 Ellicott St.Batavia, NY 14021-0549 U.S.A.1-800-950-4458 www.chapinmfg.com3. Veriﬁcación Antes Del UsoADVERTENCIAA

Kommentare zu diesen Handbüchern

Keine Kommentare

Chapin 22149XP Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Wasserausrüstung Chapin 22149XP herunter. Chapin 22149XP User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wasserausrüstung Chapin 22149XP